Submission Guidelines
Journal of Advanced Development in Engineering and Science
template manuscript
1.Articles to be published must be research articles and academic articles in engineering, basic science, applied science, agricultural technology, health science and related branches and has never been published or is under consideration for publication anywhere before.
2. The manuscript should be printed with a general document program such as Microsoft Word (.docx), using the TH Sarabun PSK font, size 14 pts. The topic uses the TH Sarabun PSK font, size 16 pts., bold.
3. Research articles should have topics in the following order: (The topic of an academic article could be tailored by the author to correspond with the content. Academic articles can use the same template as research articles.)
Title
Author' s name and Affiliation
Abstract: The length must not exceed 300 words and include 3 - 5 keywords at the end of the abstract.
Introduction: Show the problem's origin and importance, literature review and research objectives.
Research methodology: Includes information about the experimental unit, suitable methods for gathering data, experimental designs, statistical evaluation and make explicit the place and duration of the study project.
Result: Show research results
Discussion and Conclusion: It should include principles that emerge from the research and compare them with the findings of others. Suggestions for future research and other related discussion issues
Acknowledgments: (if any) for research assistants or preparing documents (but not a co-researcher)
Source of funds, agency or others as appropriate
References: APA format, follow the format in Section 6.
4.In-text citation; Use numbers in square brackets according to the order of references in the content.
Example
High concentration nitrogen in natural water body had been a dramatic water quality problem all over the world [1]. During the past decade, many researches showed that high concentration nitrogen caused eutrophication [2], effected on reproduction of mangrove forest and stimulated pH balance causing aquatic life [3]. In Thailand, there were many major nitrogen sources such as agricultural area, domestic area, commercial area and farming area causing environmental problems. Because Thailand was agricultural country, the major nitrogen source was farming area [4]. Exceed nitrogen from fertilizer and animal feces were released to natural water source and accumulated at the bottom. Due to this topic, a lot of studies try to find the best solution to reduce exceed nitrogen including; physical process chemical process and biological process [5].
Square brackets must only indicate the position of the reference. Must not affect the content described by the author.
5. Tables and figure are spaced one line apart and inserted into the content. When inserting footnotes into tables, use a numerical system to display the description. The table name should be placed above the table.
6. Reference in APA format. Arranged in order of references in the content.
6.1 Journal
Author(s). (Year). Article title. Journal title, Volume number(issue number), Number of pages.
Example
1 Author
Dubeck, L. (1990). Science fiction aids science teaching. Physics Teacher, 28, 316-318.
2 Author
Rakthai, S. & Kanoklapassakul, K. (2016). Evaluation Learning Achievement of Learning Experience Topic in Netball Athletic for High School Students. Thai Journal of Science and Technology, 5(3), 303-312. (in Thai)
Changjan, A. & Udomsamuthirun, P. (2011). The critical magnetic field of anisotropic to-band magnetic superconductors. Solid State Communications, 151, 988-992.
3 or more authors
Rakthai, S., et al. (2015). Creating Learning Experience Model in Environmental Chemistry for High School Students. Pathumwan Academic Journal, 5(14), 43-49. (in Thai)
6.2 textbook
Author(s). (Year). Book title. Book edition. Place of publication: Publisher name.
Example
Spally, M.R. & Morgan, S.S. (1989). Methods of Food Analysis. 2nd ed. New York: Elsevier.
6.3 website
Author(s). (Year). title. Available from URL. Accessed date: xx xxxx xxxx.
Example
Mackenzie, D. (2006). Instant Expert: Bird Flu. Available from http://www.newscientist.com. Accessed date: 27 January 2000.
6.4 Dissertation/thesis
Author. (Year of degree). Title. (type of publication, for example: Doctoral dissertation, Master thesis, University or Institute).
Example
Jiwalak, N. (2002). Preparation and characterization of activated carbon from lignite coal by physical and chemical activation, (Master thesis, Suranaree University of Technology). (in Thai)
6.5 Research reports
Author(s). (Year). Title (Research reports). Place of publication: Publisher name.
Example
Vadhanasin, V. (2018). Information Seeking Behavior through Social Media for Product Buying Decision via E-Commerce System (Research reports). Bangkok: Srinakharinwirot University. (in Thai)
6.6 conference proceeding
Author(s). (Year). Title. In Name of conference (Number of pages). dates of conference, place of conference.
Example
Moschandreas, D. J., et al. (2002). Contribution of the inhalation route to cumulative risk estimates from multiple route exposures to pesticides in NHEXAS-AZ residences. In The 9th International Conference on Indoor Air Quality and Climate (p. 10-18). 30 June – 5 July, 2002, Monterey, California, USA.
6.7 Book Chapter
- Print version
Chapter Author(s). (Year). Chapter or article title. In Editor(s) (Ed.). Book title: Subtitle
(edition number if not the first, pages of chapter). Location of publication: Publisher.
Example
Murphy, D. J., Jr. (2014). Coarctation of the aorta. In Moodie, D. S. (Ed.). Clinical management of congenital heart disease: From infancy to adulthood (p. 142-170). Minneapolis, Minnesota: Cardiotext Publishing.
- electronics version
Chapter Author(s). (Year). Chapter or article title. In Editor(s) (Ed.). Book title: Subtitle
(number of edition if not the first, pages of chapter). Publisher. doi (if applicable)
Example
Ebbesen, M. (2011). Cross cultural principles for bioethics. In Gargiulo, G. D. & McEwan, A. (Eds.). Advanced biomedical engineering (p. 157-183). InTech. doi: 10.5772/1017.
Submission
Submission article via ThaiJo system
https://ph03.tci-thaijo.org/index.php/pitjournal/about/submissions
Editing and acceptance for publication
1. Articles that have been considered for publication by at least 3 experts from various institutions (double-blind review) and the editorial team have been accepted for publication in the Journal of Advanced Development in Engineering and Science
2. The editorial team reserves the right to prepare journal format for publication as appropriate.
3. The journal reserves the right to accept only articles that are formatted as specified by the journal.
4. Articles, text, figure and tables published in the journal are the personal opinions of the author. The editors do not necessarily agree and take no responsibility.